Answer / sjtbehera

3% as per Is 383

Answer / mahendra mohan srivastava, acc

we have two type of silt test 1 is by volume and 2 is by
weight,
by volume in 10 min it should be 20-40%, after 3 hour 7-8%.
by weight not more then 8%.

Answer / faruk

As per IS 383 the %age of silt in sand should be kept as low as possible,preferably less than 3%. Higher %age of silt in sand can reduce the compressive strength of concrete.

Answer / abhishek

10 percent

Answer / brajesh

up to 4% in natural sand and up to 10% in crushed sand

Answer / roushan kashyap

As per IS Code:
Silt 5% by weight
Silt 8% by volume

HOW WE CALCULATE OR FIND OUT THE DEGREE OF FREEDOM IN A SIMLY SUPPORTED BEAM? IF THERE IS HINGE THEN HOW? & ALSO IN A PORTAL FRAME? PLEASE GIVE A EXAMPLE FOR EACH QUESTION.

1 Answers   CCCL, PSCI,

Explain moment of inertia?

1 Answers  

If at site iam supposed to get M30.But by mistake i got M20 mix. How could I differentiate the mix before placing?

6 Answers  

I have an plot with area 35*47 = 182.77 sq yards. Out of this iam planning to construct house with 1350 sqfeet each floor .iwanted to build a G+2 house.Need cost estimation for each item

1 Answers  

calculate the cost for AAC block wall of 15cum?

2 Answers  

How to calculate(Thumb rule) the consumption of steel per cubic meter for different concrete members. 

1 Answers   Ranka Group,

How to check percentage of bulkage of sand in RCC?

4 Answers  

What are the steps involved in the concreting process?

1 Answers  

What is "Bending moment"? Demonstrate on theory not for formula.

3 Answers  

How to arrive dry volume of concrete (1.52 to 1.57) ?

1 Answers  

what type pressure pipe use in sewerage & water supply?

1 Answers   Tulip,

give me an example of a time when you had to explain some new procedures to your co-workers for quality service delivery, how did you go about it?

0 Answers