Answer / mahendra mohan srivastava

first we can weight sample of sand then we can take it to
SSd condition then we calculate moisture and if moisture is
6 % then bulkage will 30 % so we can put 6% less water and
30% execss sand after correction.if moisture will exess to
6 % then we will take less water equal to moisture and sand
will not exceed.

Answer / rojas james

Bulkage of sand is used to determine the change in volume of sand when doing volume batching, when moisture is there in sand upto a limit the volume will increase then after saturation the volume will decrease so in volume batching if sand is having moisture the volume will be shown high than the actual and it can make the mix to segregation due to less Fine Aggregates

Answer / suresh

this is not answer.
my question ... first we check and give moisture correction.
this is ok. in that same time why we have required of
bulkage of sand..?

bulkage of sand: we have using only volumetric based place
not in weighement location.

Answer / sai

By proctor test we can find dry density,and water content by any mtd like cal. Carbide then by using formula we can find bulk density

how to take quantity in triangle section for calculating tender purpose

1 Answers  

---

how much quantity of bending wire required for 1sqmts

6 Answers   BUP, Jade Software,

---

how many cubic centimeter in one unit of sand?

4 Answers  

---

how to consider the laping length of steel?

12 Answers  

---

How much bricks in 1sq.meter with thickness 9inch.

3 Answers  

---

can i make bricks using M10 grade concrete ? and what would be the cost of a brick if we use m10 grade concrete sand and aggregates ??

0 Answers  

---

what is water cement ratio m10,m15,m20,m25,m30,m35,m40

1 Answers   Quaid-e-Azam International Hospital,

---

koi bta sakta ha ka steel ko calculate krna ka full mathod pls

4 Answers  

---

how the sand fail?

5 Answers  

---

Define What is the tensile strength of wood?

0 Answers  

---

Structural steel: For a thumb rule check in field, the allowable weight which can be hung down for 10mm dia mild steel rod, of yield value of 0, 25 KN/mm2 and applying a factor of safety 2.00, will be how many kg?

3 Answers  

---

What is mean by ITP in a construction project

6 Answers  

---