Interested to Buy Any Domain ? << Click Here >> for more details...
what is the silt(for sand) allowed persentage as per IS
CODE
B/W:
PLASTER:
CONCRETE :
- 6 Answers
- 16401 Views
- Trident, I also Faced
- E-Mail Answers
Answer Posted / faruk
As per IS 383 the %age of silt in sand should be kept as low as possible,preferably less than 3%. Higher %age of silt in sand can reduce the compressive strength of concrete.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
cud any one send me tech quest paper(civil engg) at tarizus@yahoo.com
I want to change job.If You have any vacancy please contact me in this mail id-parthamitra086@gmail.com.Myself partha mitra.Diploma in civil engineer with 4+ yrs. exp.Now in kolkata.If you confirm me then I will send my detail resume to you.Also send your mail id to me.My mail id is-parthamitra086@gmail.com.I will be very much thankful to you.
what is escalation?how it is done?
what will happen if one could not properly follow the spacing of slab reinforcement bar?
HOW MANY BAGS OF CEMEMT USED IN PER M2 OF PARTITION WALL
.5Ast
What is the cost difference between site mix and ready mix concrete per cubic meter
GIVE US YOUR FULL DETAIL OF THE FOLLOWING… FULL NAME.. PERMENENT MAILING ADDRESS DIRECT CONTACT NO E MAIL ADDRES.
what is the exact dia of 8swg and 10swg gabion wire
What is specific gravity???
How to calculate quantity of plum masonry in 1:3:7
What is the difference between 53 grade and 43 grade cement
a sewer which receives the discharge of no. of house sewer is called house sewer lateral sewer intrcepting sewer sub-main sewer
WHAT DLC DESIGN IN CONSTRUCTION
A doubly reinforced concrete beam is 25 cm wide and 50cm deep to the centre of tension reinforcement. The centre of compression is steel is 5cm from the compression edge. The areas of the compression and the tension steel are 10.16cm2 and 12.56 cm2 if m=18 and the bending moment at the section is 7,000,000 N-cm. Calculate the stress in concrete and steel.
