Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379) i need the details about bhel exam.how to apply for that.please send to my email-id.thenmozhi2k7@gmail.com
20141- Explain about HPM 2- What is the FSC and explain the configuration of FSC 3- explain the complete loop of vibration, how it works (field to control room) 4- What is the use of proxymitter? 5- During job your partner effected with H2S then what you have to do. 6- what type of gland packing uses when valve glind is leaking.
2810what is the purpose of vector group in a transformer ? if 2 tranaformers r connected in parallel the vector group is same or not? for parallel operation 2 transformers of different manufacturers maintain same vector group or not?
3 14191
High voltage test procedure of in swgr board. why should measure millivolt drop on testing time?
which book is good for electronics aptitude test?
What do you mean by effect of noise on carrier signal & what is noise segment
How much of the strength of concrete comes from post- production curing?
what is the differebt between ac and dc fuse?
When an expansion is joint needed on the shell side of a shell and tube heat exchanger?
Explain creep?
What are whiskers ?
What do you understand by collector reverse saturation? In which configuration does it have a greater value?
Where will digital and analog technology come into play in the cctv technology in terms of data storage?
The main function of transmission is a) To provide means to vary the torque ratio between the engine and the road wheels b) To provide neutral position c) To provide means to back the car d) all of the above
What is load?
why ss stablity limit is more transient stablity limit?
What is cut off relay? And why use in PLC and DCS?
What Are The Steps Involved In The Concreting Process, Explain?