Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379) 1. For Steam drum level signal, why do we compensate with drum pressure signal? 2.For main steam Flow signal is comensated with main steam temperature signal and main steam pressure signal why?
2178Before i went to bed my master bathroom lights were working fine. At 2 am, when I went to use the lights, none of them were working. The outlets throughout the bathroom work, but the lights and fan above the toilet don't. I have two panels of switches. The one panel has four switches. One of the switches turns on the hall light, and that works. The other three are to other lights, and they don't. The other panel has three switches. One of those is to the fan, and the other is to a light above the toilet. The other is a to light that is also on that other panel. I tried the breakers, and the one that turns off the outlets, marked for the bathrooom, turns on and off the outlets. None seemed to be tripped. I checked the lightbulbs, and they are fine. Please help
2 5312how do you estimate the # of bags of cement, sand & gravel.. if only given the volume of the project..
3 23041Please anyone answer my question, what is the difference between single acting and double acting control valve, in what condition we better choose single acting rather than double acting
2 7580why decoupling capacitor is used in circuit? what is the use of bypass capacitor? what is slew rate?
3 8114How can we calculate the capacity of each impeller in a multi stage pump(Condensate extraction pump having 5 stage used in thermal power station)How it varies in pumping capacity on removing different stages?
2117In Increasing temperature why thermocouple used and RTD is not used. Both RTD and Thermocouple have in Range of uses.
L&T,
5 14417
how to increase senstivity of ct
How to design binary to gray code converter?
how to decide no of electrodes for 1600A LT Main incomer panel
what is modular brick and it size
How can you produce desired alloys and discuss their applications in daily life.
from where the self excitrd induction generator get the power?why is the voltage regulation is poor of seig?
Why iso-octane is chosen as reference fuel for s.i. Engines and allotted 100 value for its octane number ?
what are differences between composition and inheritance in c
relate the frequency between feed water treatment & blow off
Is it possible to operate a synchronous 2-poles turbogenerator with a still-in-place faulted bar but electrically disconnected ???? If yes, should I act on the other phases as well ???
What are the error values can accepted in flow transmitter calibration?could u give any formula for this?
What is self exciting?
How would you calculate power loss in a resistor?
am a textile eng. frombut with major of my course including chemical eng, subjects, can i too apply to the co.?
Describe transfer machines?