What should be the voltage between neutral and earth of a
UPS?

Answers were Sorted based on User's Feedback



What should be the voltage between neutral and earth of a UPS?..

Answer / bhatti

idally u can says 0 volts,but practically it is not
possible to attain 0V due to soil or environmental
conditions.it might be as low as possible near about 1-2V
Max.
Otherwise put water ,check earthing wire....etc.

Is This Answer Correct ?    13 Yes 0 No

What should be the voltage between neutral and earth of a UPS?..

Answer / vishant

ideally it should be 0
but practically we will get say 1 to 2 volt

Is This Answer Correct ?    6 Yes 0 No

What should be the voltage between neutral and earth of a UPS?..

Answer / chetan

because of UPS Output is connected generaly with isolation
transformer output is always star so neutral is ground so
voltage between star and neutral is always minimum 0 or 1
around.....

Is This Answer Correct ?    0 Yes 0 No

What should be the voltage between neutral and earth of a UPS?..

Answer / kiong yu

0 volt

Is This Answer Correct ?    2 Yes 3 No

Post New Answer

More Electrical Engineering Interview Questions

Compare OH Transmission & UG Transmission?

2 Answers  


-What should be minimum value of insulation resistance and maximum value of earth resistance at any electrical instillation and what is method of testing the same.

1 Answers  


why some time Railway Fan not Rotate,But after a small rotation by human then it rotate normally? Why?

4 Answers  


what is rotating transformer? what is the uses of it?i mean applicaitons?

5 Answers   First Lead,


our factory is going under construction mean time transformer 1000 kva 2 nos &load break swithch 12 kv & 4 nos 750 kva 2 nos & 380 kva 2 nos generator to be errcted.how to arrange earth pits &how to earth connect & neutral pit how to calculate in earth bit size.

1 Answers  


What is application of MCB & How it works

1 Answers   TATA,


Technical equations

1 Answers   ME,


why are u join ntpc

1 Answers   NTPC,


I HAVE BEEN SELECTED FOR APGENCO A.E(ELECTRICAL) 2008.HOW MUCH WEIGHTAGE FOR INTERVIEW AND WRITTEN TEST.HOW I HAVE TO PREPARE. PLEASE GIVE INFORMATION IF U KNOW.WHAT ABT G.D THIS TIME.CALL RATIO 1:2

0 Answers  


transformers? power factor? machiences?

3 Answers  


Can I parallel 1 MVA generator with 1kVA Generator? if V, F, Ph Seq and Ph angles are same

2 Answers  


how much earth resistance consider to commissioning the transformer?

3 Answers   Deccan Cements,


Categories
  • Civil Engineering Interview Questions Civil Engineering (5086)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4453)
  • Electrical Engineering Interview Questions Electrical Engineering (16638)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)