Answer / Jai Kant Rangila

To ensure electrical safety, there are minimum and maximum values for insulation resistance (IR) and earth resistance (ER) that must be maintained at any electrical installation. The specific values can vary depending on local regulations, but here are some general guidelines:

1. Insulation Resistance (IR): IR should be as high as possible, ideally greater than 1 Megohm (MΩ). In some cases, a lower value may still be acceptable if it meets local regulations and safety standards.
2. Earth Resistance (ER): ER should be low enough to minimize the risk of electrical shock but not too low that it affects the performance of protective earths. Commonly, a minimum ER value of 0.5 ohms (Ω) is required for most installations.

Testing insulation resistance and earth resistance can be done using a Megohm meter or earth tester. Consult with an electrical engineer or local regulations for detailed testing procedures.

Why stand-by earth fault relay and restricted earth fault relays are connected between neutral and ground in transformer?

1 Answers  

---

Explain the process of commutation in a dc machine.

1 Answers  

---

Explain the following and how these are working with PLC Unit 1 I/O Module Card 2 Adaptor Card 3 Ribbon Adaptor 4 I/O bus 5 I/O Devices

1 Answers   Mayur,

---

WHY TRANSFORMERS ARE RATED IN 11KV 22KV 33KV Instead off 10kv 20kv 30kv

5 Answers  

---

In transmission line the line power loss only accured at resistance the inductance and capacitance wont consume power is it correct?

2 Answers  

---

why we did not get shock by touching +ve OR -ve busbar (Which are going to supply cell voltage) of Rectifier- Tranformer in electrolysis plant?

4 Answers  

---

Where can i get practical knowledge of solar system?

1 Answers  

---

What is Grounding? any difference b\w earthing? if yes plz explan??

3 Answers   ABB,

---

can anybody tell me that for p.f. Improvment we use capacitor banks but how to decide its capacitance. As we all know how to calculate kvar but what abt capacitance value

1 Answers  

---

What is the difference between diode and a transistor in terms of the direction of current flow?

1 Answers  

---

how many BUSBAR is in electrical system?

3 Answers  

---

what is the difference betweem star connected motor & delta connected motor?

13 Answers  

---