i have 400/230v transformer and didnt done the neutral eatrhing. i connected one lamp to one phase and neutral to the earth. but the lamp is not glowing. again i connected neutral to earth and repeated the same. then the lamp is glowing. in the first condition i tested with a line tester also, at that time the tesrer is glowing what is happening i dont know can any one help me?

1 Answers  

---

What will happen if mains neutral and generator neutral shorted?

2 Answers   Betts, Suzlon,

---

What are the material used for inductance coil?

0 Answers  

---

what is the different beetween kva and kwh?

4 Answers  

---

In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes

0 Answers  

---

What are the types of Bus bar?

8 Answers   CTEVT,

---

what is the working principle of Brushed alternator ? without exictation how we can give dc supply to rotor ?

1 Answers  

---

What is the unit of charge and current?

0 Answers  

---

can we load Power capicitors on DG sets?

14 Answers   Neptune, Nimbus, Westin,

---

What is the relation of current with torque when motor started in Y-connection???

4 Answers  

---

delta motor winding resistance I take normally single winding is 2.5, which value is came delta connection ie RY ?

0 Answers  

---

what do w do when the output of generator is fluctuating?

0 Answers  

---