Interested to Buy Any Domain ? << Click Here >> for more details...
What should be the voltage between neutral and earth of a
UPS?
- 4 Answers
- 10820 Views
- I also Faced
- E-Mail Answers
Answer Posted / kiong yu
0 volt
| Is This Answer Correct ? | 2 Yes | 3 No |
Post New Answer View All Answers
how to failure indution motor insulation & how to improve heat in motor insulation
How to decide and select the different earthing wire size for the different types of earthing
What is the complete procedure of erection of electrical panel in industry
what is under coal gassification?
A 7 storey building has a floor area of 35,000sq.ft on each storey. On the ground floor 11KV electrical sub-station is to be erected. A load of 3kw for every 400sq.ft (p.f is 0.8) is proposed for each floor. fire pump 7.5hp, water pump 5hp, lift 2 nos, each 10hp and 20shop load of each shop is 5kw. calculate a. load each floor b. total load of building c. L.T feeders for aech floor and from transformer to main. d. distribution diagram e. capacity of sub-station/capacitor bank f. line diagram
Differentiate between induced emf and self inductance?
What the formula for calculating no.of earthings & size of earth strip for 100mX90m shop.
ELECTRICAL ENGINEER TEST IN FEWA ANY ONE HAVE KNOWLEDGE ABOUT THIS?????????
What are the uses of stepper motor?
A powerplant has 8 gensets operating in grid parallel mode. In one genset sometimes there is pf variation and kvar variation. The plant operates in pf mode. When this variation is observed the load is stable, voltage is also stable, freq and genset speed is also stable. How will you check the functioning of pf card. What shall be the ideal output vdc of the pfc, from there it is input to AVR?
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The rotor reactance at stand still is A 2 ohm B 1.25 ohm C 3.15 ohm D 2.25 ohm
What Should be the value of Vector Surge angle at Tripping and how to calculate it?
How to determine the breaking capacity such as break down current and break down voltage for VCB and CT's.
If Dg set load increase 25%, How much increase fuel Consumption (15 kva 2 cylinder DG set)
What is tranformer differtial?
