while grounding the galvenized metallic structures is it
necessary to remove the galvenization at the point of
contact? Or other wise is the galvenizatio a good conductor?
Answer / amrinder singh
yes it is necessary to remove galvanisation.
Is This Answer Correct ? | 1 Yes | 2 No |
In a 11Kv/433Volt Delt-star step down transformer one one line(Line-B) of HT site is open & earthed on DP structur. What will be the voltage on LT side R-Y, Y-B,B-R and R-N, Y- N & B-N?. Please help to understand the problem with examples. Arvind , Jaipur.
State the methods of improving power factor?
How to calculate rated currennt Of Mcb for 2hp motor...
From stability point of view,What(higher/lower) should be the value of inertia constant of rotating machines?
which type of motor is suitable for water suction pump ?
What is mean by PID controller? And what is its Long form?
What Should be the value of Vector Surge angle at Tripping and how to calculate it?
why when i start my diesel generator it takes 1 minute or less then stop, and i checked the oil sensor is ok and when the generator start i can get 220 voltage but it it is stop after 1 minute or less, how can i solve this problem?
What is the function of neutral CT in transformer? Turn ratio of typical CT for 2MVA transformer ? or relation between full load current of transformer and neutral CT ?
1 Answers Electrical Inspectorate,
Difference between rating factor of cable and derating factor of cable?
What is mean by power factor?
18 Answers Shreem Electric Ltd,
what is ring main unit?