Which instrument used to calibrate the pressure switch?
- 8 Answers
- 12708 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / vijay vaidya
pressure calibrator or dead weight tester
| Is This Answer Correct ? | 19 Yes | 3 No |
Answer / biswarup das
Answer 1 and 2 is absolutely right .
another way is to use comparison tester.
| Is This Answer Correct ? | 7 Yes | 2 No |
Answer / g.paden
druck pressure calibrator and dead weight tester
| Is This Answer Correct ? | 4 Yes | 1 No |
Answer / s.arun raja
For Pressure Switch Calibration Should be need Comparison
Pressure Test Pump and We Can't use Dead Weight Pressure
Guage Tester , Because Pressure Switch We Should Calibrate
Raising or falling Method and for Nc/No Checking need
Continuity Tester or multimeter.
| Is This Answer Correct ? | 2 Yes | 0 No |
Answer / b0nz0
Referring to the previous answers, a deadweight tester
should not be used as it is only accurate when the weights
are 'floating'.
It is much better to use a Druck or comparator as the
pressure can be varied above and below the setpoint.
| Is This Answer Correct ? | 0 Yes | 0 No |
Answer / samir patel
any type of dead weight tester,multifunction pressure
calibrator,multimeter
| Is This Answer Correct ? | 0 Yes | 1 No |
how we can calibrate split range control valve?
what is the way of measuring air flow in air duct?explaim instruments used and DP creation in line?
how level can be measured in open tank with reference to pressure
what is the advantage by using PID controller than P& PID?
How to Calibrate variable Head flowmeter (Orifice), here we dont know High pressure and low pressure then how to apply pressure on HP and LP side ?
If The RTD(PT100) Show .776 Kohm Resistance the Temperature of process fluid how much?
what is the control valve?how many types of control valves are there
6 Answers Chemin, Hindustan Zinc,
what is the diffrence between plc&dcs
4 Answers HCL, Hindustan Zinc,
Transmitter reading is zero but in DCS showing one Bar what is the reason ?
why using negative supply for bentley nevada vibration system ?
what about your moleg in pogrees with company
what is diff between sensors and transducers.explain with ex?
-
Civil Engineering (5086) - Mechanical Engineering (4453)
- Electrical Engineering (16638)
- Electronics Communications (3918)
- Chemical Engineering (1095)
- Aeronautical Engineering (239)
- Bio Engineering (96)
- Metallurgy (361)
- Industrial Engineering (259)
- Instrumentation (3014)
- Automobile Engineering (332)
- Mechatronics Engineering (97)
- Marine Engineering (124)
- Power Plant Engineering (172)
- Textile Engineering (575)
- Production Engineering (25)
- Satellite Systems Engineering (106)
- Engineering AllOther (1379)
