Which instrument used to calibrate the pressure switch?
- 8 Answers
- 12707 Views
- I also Faced
- E-Mail Answers
Answer Posted / b0nz0
Referring to the previous answers, a deadweight tester
should not be used as it is only accurate when the weights
are 'floating'.
It is much better to use a Druck or comparator as the
pressure can be varied above and below the setpoint.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
can any send me a forbes marshall dtron 316 manual
principle of dead weight tester ?
please any body have most important data for study for saudi aramco test of instrument QC thanks email shahnaveedullah@gmail.com
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
sir, give me placement papers and interview quistion of birla group company of copper.
give me all the details about the interview and which type of question being asked
please tell no. & add. of consultancy who recruit me in power plant as instrumen engg. present i m working in power plant as ass.t instrument engg. thanku mahesh 09226562826
please send data bank of quetions answers on analytical instrumentation.
Can any body help to get Rsemulator 5000 free from internet if possible then give me any link or any help .
can any one tell me when ongc placement test and its forms is available????/ pls tell me if u know
sir, i preparing hpcl,ongc,barc,hal exams(instrumentation engg)pls send a placement papers
this site is owned by an nonsense
DEAR SIR/MADAM MY NAME IS ARKAPROVA BHATTACHARYYA.I AM A FRESHER INSTRUMENTATION ENGINEER.CAN YOU PLEASE SEND SOME QUESTION PAPERS OF GRADUATE ENGINEER TRAINEE EXAM OF DVC(DAMODAR VALLY CORPORATION).MY EMAIL IDs ARE arka_aec@rediffmail.com.
send me model hpcl questions pleas..........my mail id mohideen.dharvesh@gmail.com
plz send me general of ongc
