What is the specification of service line (ie from
electrical post to cut out) used by electricity boards used
in india.i mean which material,its size etc..
please give the answer at lalkishan.p@gmail.com
No Answer is Posted For this Question
Be the First to Post Answer
why we use sinosidal voltage / current instead of others in system?
difference b/w bus bar and tie line?if possible explain with eg:
what will happen when choke in tube light circuit was not working???
galloping in transmission line is due to
orifice sizing how done, checking & selection
effect of single phase transformer on full load current?
how to CHECK CT AND PT AT THE FAULT OCCUR IN GENERATOR RELAY PANEL .
Suppose a 3 phase, 2 pole, 440V induction motor is driving a flywheel of 600mm diameter, 150kg mass. By using v-belt and pulley, the speed is increased to 4500 RPM. What will be the effect on motor current?
What is an order of a system.
WHAT IS THE FULL FORM OF ONAN ( TYPE OF COLLING IN TRANSFORMER)
why cont we short earth and N.......?
Explain about c.t?