To measure insulation resistance of 11KV cable between core & armour, what

To measure insulation resistance of 11KV cable between core
& armour, what should be the test voltage & duration?

Question Posted / mahesh

4 Answers
14865 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

To measure insulation resistance of 11KV cable between core & armour, what should be the test ..

Answer / v.senthilkumar

To measure insulation resistance of 11KV cable between core
& armour, we can use 5kv megger for 60 Sec.

Is This Answer Correct ?

22 Yes

2 No

To measure insulation resistance of 11KV cable between core & armour, what should be the test ..

Answer / thowsif_emerson_csm team

To measure insulation resistance of 11KV cable between core
& armour,

Test voltage is 28KV(RMS Value)
Duration is 300 Sec...

Is This Answer Correct ?

10 Yes

6 No

To measure insulation resistance of 11KV cable between core & armour, what should be the test ..

Answer / narendra sharma

11 kv cable resistance we can measure

Test voltage is 10 kv to 20 kv (RMS Value)
And time is depend on which voltage you are selected.
if 10 kv then time should be 120 sec..........
And resistance valu also going opposit to voltage..
if suppose volt is 10 kv then megger valu 2gomh, And if volt
20 kv and valu 1gomh then cable is ok both are same valu....

Is This Answer Correct ?

4 Yes

1 No

To measure insulation resistance of 11KV cable between core & armour, what should be the test ..

Answer / sujeet pandey

To measure the insulation resistance of 11kv cable, we need
to keep Megger test voltage at 1kv and take 2 readings; one
at a interval of 15 sec and other at an interval of 1 min.
This will give Absorption Factor which is equal to ratio of
resistance at 1 min to the resistance at 15 sec. If the A.F.
is less than 1.2(a/c to Indian Standards) then the
insulation is not good and we must take the remedy action.

Is This Answer Correct ?

0 Yes

1 No

Post New Answer

More Electrical Engineering Interview Questions

how can we know cable size for a given current? if any one have catalogue plz mail to vijay_raju369@yahoo.co.in

5 Answers

prefer any good electrical engineering book.....it should be useful in the practical fied?

1 Answers

How do i perform grounding of star point of Genset (400V) for making connection with step up transformer of DELTA-DELTA (400V to 20KV) ? while Genset itself has its own neutral and grounding bus bar inside genset breaker box whereas we have another neutral and grounding busbar in synchronizing panel next to genset at maximum distance of 6meter, would someone pls advice if we can only perform neutral grounding in synchronizing panel or should we ground neutral on both places inside genset breaker box and synchronizing panel.

0 Answers Allied Group,

on which power factor synchronous motor run

2 Answers Bhel,

What magnetic circuit is formed in berry-type constructions and why?

0 Answers

How Diesel Generator start ?

0 Answers ITC Infotech, Voltech,

Please sent me some previous year question papers of BSNL-JTO telecom and RRB in ELectrical Engineering to varshashahi@yahoo.com

0 Answers

differnce between single acting and double acting solenoid valves

0 Answers

how many earthing is required for sever room?