IF we want to replace I/C bay at our 220 kv substation which is of 140 mw load

IF we want to replace I/C bay at our 220 kv substation which
is of 140 mw load capacity bay to be replaced by 400 mw
capacity bay.other than CT(1200/1) what are the other
equipment i have to replace.

Question Posted / manish1090

1 Answers
4059 Views
Jindal, I also Faced
E-Mail Answers

IF we want to replace I/C bay at our 220 kv substation which is of 140 mw load capacity bay to be r..

Answer / k.prakashchandra

cb,isolator and conductors

Is This Answer Correct ?

3 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

How do you find HT and LT sides of a distribution transformer only by looking at it from outside?

1 Answers Nespak,

how to calculate the surge level of surge suppressors related to the SF6 cicuit breakers?

0 Answers Crompton Greaves,

What is the starting current of a motor?

3 Answers

why we are using DC violtage for testing of cables....which is used in HV AC applicatons...

1 Answers

explain why the armature voltage changes when the field rheostat is varied in self excited DC generator

2 Answers

Dear Sirs, I am a technical persons.In one of our Electrical Sub- Station, We have installed three numbers of 1250KVA ,11KV/0.415KV Transformer to feed the Factory load. We have found some abnormality. In one of our Transformers the leakeage current from transformer body to earth through earth continuity wire is almost 86 Amp but in other transformer it is (5-10)Amp. where the load current on three phase and neutral are respectively 1360Amp,1400Amp,1370 Amp & 176Amp. So please any technical person help me about the reasons of this situation and how I can rectify the fault. Moreover,I have measured the earth resistance of the Earth continuity wire which is less than 1 Ohm. Thanks Tapas Barua

3 Answers

How to improve insulation resistance of Motor

2 Answers

explain remenance . differentiate high remenance type ct & low remenance type ct

0 Answers Coca Cola,

As we use capacitior bank in 3ph ckt for improvement of PF, why not we use capacitor in single phase domestric use, at our house their are many inductive equipments,like fan,mixer,tube choke,air conditioner they also draw PF... by using capacitor can they improve PF. if yes--what are advantage and how to connect a capactor in single ph,and which type of capacitor if no- what are disadvantages.

0 Answers

What are the causes of having an rmu explode after installation? And how do u treat the bushings of an rmu?

0 Answers JKN Limited,

what is lowest system voltage?

7 Answers Apex Holdings,

List any four conventional sources of energy.

1 Answers

For more Electrical Engineering Interview Questions Click Here