Answer / harshad

you can reffer IS465-2000 or reffer the book of RCC by
B>C>Punmia.

Answer / vinesh

in SP34

Answer / jambu

You can refer IS 1749 and BS 4449...
till if you want more refer ASTM,DIN codes

Answer / abinash

you can follow ACI 318. Its good for Detailing.

Answer / talha

you can refer the limit state design by author shah & karve

What is the per cu. mt. price of ready mix in Gujarat region.?

0 Answers   Neptune,

suppose we have a tendency to make a hole on the surface of the beam, than where we goes to make it?

3 Answers  

Cement sand mortar ratio 1:6 and 1:3. In canal lining 10mm & 16mm respectively done after 24hrs difference between them . Tell me Torrence limit of above ratio after 1 Year .

0 Answers  

what is a pitot tube

5 Answers  

what is the density of fine sand grade-2

3 Answers  

For a RCC section with congested reinforcement , what is the compaction factor

3 Answers   Arihant, GMR, Gulf International Contracting, NBCC,

how many mason and labaur work for a 1 brass bricks plz let me know the calculate & how to made calculation for this and whats the formulas for this?

0 Answers   NCC, Sobha Developers,

find the discharge of water through a horizental venturimeter having 400mm dia at the inlet main and 150mm dia at thorat.if the diffrential gauge between inlet and thorat shows a pressure head of 25cm mercury. assume coefficient discharge 0.98 and specfic gravity of mercury as 13.6.

0 Answers   UPSC,

what is the labour requirement for solid & hollow block work

1 Answers  

what"s the merits and demerits of hollow blocks comapre than to bricks?

1 Answers   Punj Lloyd Ltd,

for concrete cubes samples.. what if the 7 days gain the strength of 42.34 mm/2 and the 28 days only gain the strength of 37.5 mm/2?

2 Answers  

4. Differentiate between NC and OC soils. Draw curves for (i) Stress vs Strain (ii) Volume charge vs Strain (iii) Pore pressure vs Strain for these soils

0 Answers