WHERE IS THE LIGHTING ARRESTER SHOULD BE PLACED IN
DISTRIBUTION LINES?
- 6 Answers
- 6885 Views
- Bhel, I also Faced
- E-Mail Answers
Answer Posted / v.senthilkumar
In high voltage Sub station, LA to be placed at transformer
end and input line end to protect our incoming line,
Substation equipments and transformer.
| Is This Answer Correct ? | 10 Yes | 0 No |
Post New Answer View All Answers
What are the main advantages of generalized error co-efficients?
What is hipot test procedure?
Whether IP65 enclosure box blocks ventilation if driver for LED have to enclosed inside IP65 box
where we use the SFU & FSU?
our factory is going under construction mean time transformer 1000 kva 2 nos &load break swithch 12 kv & 4 nos 750 kva 2 nos & 380 kva 2 nos generator to be errcted.how to arrange earth pits &how to earth connect & neutral pit how to calculate in earth bit size.
WHAT IS SITTING AMPS IN OVER-LOAD RELAY FOR 1PH OR 3PH MOTORS?IF ITS NAME PLATE GIVEN MAX AMPS 10AMPS?
What is the maximum No. of out going mccbs permitted from an LV distribution paqnel? What is the ampere relation between incomer and out going switch gears/mccbs?
What are the different types of LT Cables?
Define active and passive network?
how to CHECK CT AND PT AT THE FAULT OCCUR IN GENERATOR RELAY PANEL .
what is the step by step formula for calculating bus bar phase and neutral size of a panel board.suppose the incomer of panel board is 100A..???step by step answer please
Phase control and integral control are used for?
In TNC switch, is there any 1NO+1NC block ? and if we move over closing position, is ther any affect on trip position or vice versa?
Did RMU have ct and pt ?
what is the difference between megger and earth resister ??
