Interested to Buy Any Domain ? << Click Here >> for more details...
WHERE IS THE LIGHTING ARRESTER SHOULD BE PLACED IN
DISTRIBUTION LINES?
- 6 Answers
- 8604 Views
- Bhel, I also Faced
- E-Mail Answers
Answer Posted / gunasekaran
1.transformer incomer.
2.transformer bushing like horn type.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
plz send me the syllabus or any sample paper for engineer trainee recruitment if any,on ravinder911@yahoo.com
what is feed back and what are feed back amplifiers?
In India the supply voltage is 230 volt A.C. During the negative half cycle phase becomes neutral and neutral become phase? or what will happen during negative half cycle? how the electrons flow during positive and negative half cycle?
we have two generators different capacity on 15 MW and other 6MW at 11 KV , 15 MW gen. bus short level current 40KA,and 6MW short level current 25KA,, length of cable 100MTR between 6 MW from 15MW gen. for bus coupling . kindly tell any one can we use both NGR OR one NGR from any GEN. BOTH NGR has diff. rating. Tariq pakistan
We normally make oil soak pits under Transformers. Oil from soak pit goes to collection pit. We provide granules/pebbles under transformers. My question is weather granules/ pebbles to be filled in soak pit or not? if yes upto what level?
what are carbondioxide and dcp used in fire extinguishers
what is the reqirred voltage in HT motor to get full RPM on no load test?
i have seen one 8.4 MW synchronous motor in a plant located in bellary it is fixed with brushless rotary rectifier ,anybody can explain its start up principle
how pt is using
What is the formula to calculate the no load current of a single & three phase induction motor
What is the formula to calculate the rating of a three phase air circuit breaker
What conditions are required for transformer to operate at low frequencies ?
when the Transmission and Distribution network where is the "feeder" lines are located? and why should be used in T&D network.....
Dear Brother can u tell the proper size selection of cable & the fault level calculation of braker, busbar etc. pls mail me at azeemk30@gmail.com
When a single pase capacitor run motor- run on 230vac and Case(1)run with 8 Mfd 250 vac.capacitor , Case( 2) run with 8 Mfd 400vac capacitor. What is difference between both case regarding power ,efficiency etc?
