Answer / vijay

If CT IS OPEN UNDER LOADING CONDITION IT WILL BURST.

Answer / k.prakashchandra

Nil

Answer / manohar

when ct is open circuited there is more voltage at the open
ends. this voltage may dangerous, if touch it you feel
sevior shock. The ct turns will act secondary itself & the
voltage will be equal to
voltage at bus or cable X No.of turns of the ct
which leads to leathal voltage & the current path is open
thus circuit is not completed.We aRE using ct's for metering
& protection. The metering ct will not get saturarated after
its rated VA immidiately but the protective ct's are GET
saturarated after its rated VA.

Find active & Reactive Power transmitted in a transmisston line having Vs30 degree(sending end) to Vr(zero degree)at receving end with line inductance X ohm. Vs(30degree)-------------------Vr(zero degree) X ohm

3 Answers  

---

bit confused - am i correct in thinking that to determine line to line voltage in a star config 110v 3 phase 4 wire distribution system i would use a voltmeter? I have a circuit configured as an unbalanced load, consisting of three incandescent lamps (1x40w, 1x60w, 1x100w - all 110v rated)connected in a star configuration to a 110v 3 phase 4 wire distribution system. I want to find out what types of meters i would use to obtain: a) each line to line voltage b) the line to neutral voltage across each load c) current flowing in each line and load d) current flowing in the neutral conductor e) power supplied to the loads im assuming i would be using ammeters in series along each line and voltmeters in parallel across each line to neutral? Also how could i predict these meter readings before taking them and with which formulae? Any help would be greatly appreciated A.

1 Answers  

---

basic princple of induction and synchronous motor

1 Answers  

---

how DC is differ from AC ? what are the difference between them ?exept (P-N)&(+__-)

2 Answers  

---

why we use end termination kit for ht xlpe cables

1 Answers  

---

when generator of a power plant is not connected to grid , by increasing the mechanical torque speed of rotor increases but when it's connected to load instead of increase in speed current increases , why?

1 Answers  

---

how to set earth fault relay

1 Answers  

---

what is the method of earthing of a transformer using electrodes?

0 Answers  

---

WHY IS THE SIZE OF HOLE OF THE EARTH POINT IN THE PLUG POINT BIGGER THAN PHASE AND NEUTRAL

7 Answers   Jindal,

---

why do star-delta connection ? why do not connect any circuit direct connection ?

1 Answers   IBM, Sri Biotech,

---

WHAT IS INERTIA,AND WAT IS TORQUE.

0 Answers  

---

why the Parameters : Base Voltage & Maximum Voltage can't be equal in value in a VFD (Variable Frequency Drive) ? How much the base voltage would be lower than the maximum voltage ? If 400 V is the 3 phase output of a VFD ... then what should be the base voltage ? thanks a lot

1 Answers   Yaskawa,

---