Answer / koti

Motor Operated Valve

Answer / kj

Most likely what you are looking at is a Metal Oxide
Varistor. This a a component which will start to conduct
when the voltage across it reaches a pre-designed level.
They are normally used to absorb spikes where these can
damage electronic components. Placing a MOV across the
input will shunt any spikes through the MOV and prevent it
from damaging other components.

What is Toroid?. What is the difference between toroid and Current Transformer

1 Answers   DAE,

---

why middle phase should used for earth fault and other phases used for over current in overcurrent and earth fault relay?

7 Answers   ABB, ONGC,

---

we specify current in case of feeder but in case of distributor voltage, why?

0 Answers  

---

How to model two generators into a single generator ? Eg. two generators connected to a bus, would like to model it as a single generator connected to a bus.

0 Answers  

---

How much pf maintan in dg set in 6o% load,when Dg runnig Neutaal Earthing removed what happen.

0 Answers  

---

if transformer winding burn on dc supply then why not alternator rotor winding please post answer on y.sakhare@rediffmail.com

4 Answers   MahaGenco,

---

what is the instataneous value of voltage in a 3-phase balanced star connected circuit?

6 Answers  

---

Is it required to do earthing in 2nd shop if earthed armoured cable is laid from 1st shop ?

0 Answers  

---

Railway Basic electrical engg technical question with answer

1 Answers   Indian Railways,

---

explain the application of reciprocity theorom

0 Answers  

---

why the generator will take 8 to 12 hours to start after it got interrupted due to technical problems in case of power plants.

1 Answers   NTPC,

---

1.What is isolators and bus bars?give answer in details

2 Answers  

---