Answer / lalu

no load current depeds on motor ratings

Answer / ezhil

One third of the full load current of the induction motor

Answer / shivam

actually it depends upon no load losses of machine....if we are talking about ideal machine so there will be zero current because of zero losses...output=input-losses ...here output will be zero...hence whole power will consume to meet no load losses...since this is universal equation so apply with every machine

Answer / mihirlio1991

its simple

its a rated current not more

Answer / lousy.lass

5 times of the rated value

Answer / kanhaiya sharma

the no load current 2 to 5% of the full load current

Answer / ashwin

It primarily depends on the type of the motor (whether it is Ac (synchronous or induction)or DC motor) and then the rating of the motor.

Answer / tarkeshwar

5% of the full Load

hi can you give any body fault level calculation, generator fault level calculation,transformer fault level calculation for system fault level with equation? i have 3.3kv generation voltage three gas gen sets, one is 1.9MW,2nd is 2.5MW,& 3rd is 3.8MW & i have 11 kv generation voltage one gas gen sets is 3.8MW, we are step up to 22kv by transformer

3 Answers   Hindalco, Piramal Healthcare,

What is the diference between increased saety motors and non sparking motors?

1 Answers  

what is meant by magnetic flow meter ? explain its working principle ?

1 Answers  

WHAT IS THE DIFFERENCE BETWEEN VOLTage and potential diff

5 Answers  

What happens instead of using 3 phase, if we give loop of single phase to all three phases ??

1 Answers  

a solar energy installation utilizes a three phase bridge converter to feed energy into power system through a transformer of 400v/400v.the energy is collected in a bank of 400v battery and is connected to converter through a large filter choke of resistance 10ohms.1.the maximum current through the battrey will be.2.the kva rating of the input transformer is.

1 Answers   GATE,

Why 5kv megger used to megger 6.6kv motor or 33kv transformer why not 500v?

2 Answers  

We have 420volts, Diesel gen-sets each 750kva 4nos. we are operating with bus bar duct having 10x150mm for each face 4nos. our question is what is the minimum gap required between each face? is there any satutory regulations?

1 Answers   Alliance One,

how to increase or decrease speed in DC shunt motor by DC convertor

0 Answers  

what is the diffrence between capasitor and battery?

2 Answers  

The loads are connected with phase and ground then why current flow as the loads ?

0 Answers  

What is mean by nominal voltage,Explain?.How much nominal voltage?.

1 Answers