Answer / prashant

When we are qouting for a project its on the basis of
TENDER DWG
After that we start prepearing the SHOP DWG ie for use at
site and as per this dwg work has to be executed at site
Finally we have to prepare the AS BUILT DWG ie the exact
dwgs as to how the work was carried out at site bcoz at
site due to the site conditions the site engg mite have
laid the wire or the conduits thru a diif path as shown in
the shop dwg. All such deviations are to be shown in the AS
BUILT DWG

Answer / hamid

the shop drawing is engineering DWG and may can be
change during the construction or installation of
equipment after test .
the Hasbult drawing is the final drawing after
commissionning of installation and the last change if it
has a changement

what is the basic construction diffrance between servo motor ans sqiralcage induction motor

0 Answers  

---

what is meant by CT burden = 10 VA?

1 Answers  

---

Earth has zero potential then what would be the neutral potential ?

0 Answers   JLL,

---

1. what is the meaning of bus? 2. what is the dc transformer? How it work 3.what is the function of the serge absorber? 4.How the CT and PT rating calculate/

1 Answers  

---

What is the function of Harmonics filter, and how to calculate that rating of the energy saving?

1 Answers  

---

how to deside the capacity of chock for drive?

0 Answers   Essar,

---

What happened If 3phase supply connected to slip ring side of slipring induction motor ?

2 Answers  

---

What loads the lagging and leading effects comes in a circuit?

5 Answers  

---

when the PFR (POWER FACTOR REGULATOR)change a step to zero,one of the RCCB will triped off,is it the changing step of this PFR effect the RCCB?

2 Answers  

---

how to calculate the breaking capacity of different breakers.

0 Answers   UltraTech,

---

why breaker closing coil gets burnt if supply is continously provided to it.

1 Answers   TATA,

---

What is the different between Insulator & Di-electrict?

2 Answers  

---