why breaker closing coil gets burnt if supply is continously provided to it.
It is short time rated ,say about 5 seconds max .
Is This Answer Correct ? | 1 Yes | 2 No |
What is the difference between PS & metering CT (5p20,0.5 etc.)? Why in PS class CT only Vk is given ? Is PS class CT is more accurate than metering CT?
WHAT IS FAULT CAPACITY OF HT MOTOR TERMINAL BLOCK? ANY BODY HAVE ANSWER PLZ....POST IT.
In layman terms, what is the difference of Dielectric strength and dielectric constant when speaking of an insulating oil
What is mean by % impedance of transformer? detail explanations expected.
CBCT selection
how kva rating of transformer is calculated.
6 Answers Fluor Daniel, Siemens,
Name the test signals used in control system
if there are six generators (3 gas CATT, one Jenbacher o1 MW each, and two nos Diesel 01 no 01 mw other 0.65mw EDGs ( say), 3 CAtt gas set have identical pole pitch,01mw EDG and Jenbacher gas Set have different pole pitch, how their power connection can be done to connect a common bus bar during installation. in short, how different pole pitched generators power connection can be done to connect a common busbar system through generators incomer ACBs.
I have 2500KVA transformer delta/star,13.8KV/380V provided with LV 4000A breaker. Already I have 2300KW motor feeder with a full load 90%. Is it possible to connect another 1600A from that breaker? If so how the calculation is done?
I PURCHASED A DEISEL GENARATOR SET OF AVR TYPE& RATING 125KVA BUT SOME TIMES THE OUTPUT VOLTAGE IS FLUCTUATING WHAT ARE THE PROBABLE REASONS GIVE ME
Why arc quenching is used in Diode ?
What is Tan Delta Test