Interested to Buy Any Domain ? << Click Here >> for more details...
WHAT IS THE DIFFERENCE BETWEEN SHOP DRAWINGS/ DESIGN
DRAWINGS AND AS BUILT DRAWINGS??
- 2 Answers
- 30034 Views
- ACC, Al-Jaber, Dubai Group, ECEC, I also Faced
- E-Mail Answers
Answer Posted / prashant
When we are qouting for a project its on the basis of
TENDER DWG
After that we start prepearing the SHOP DWG ie for use at
site and as per this dwg work has to be executed at site
Finally we have to prepare the AS BUILT DWG ie the exact
dwgs as to how the work was carried out at site bcoz at
site due to the site conditions the site engg mite have
laid the wire or the conduits thru a diif path as shown in
the shop dwg. All such deviations are to be shown in the AS
BUILT DWG
| Is This Answer Correct ? | 53 Yes | 8 No |
Post New Answer View All Answers
In general bus riser follows the bus section in SWGR. What are impacts if bus section follows bus riser?
Explain the working principle of Synchronous Generator and Assynchronous generator?
please send me jindal previous aptitude and technical question and answer.my email id is deep_raj@live.com
our factory is going under construction mean time transformer 1000 kva 2 nos &load break swithch 12 kv & 4 nos 750 kva 2 nos & 380 kva 2 nos generator to be errcted.how to arrange earth pits &how to earth connect & neutral pit how to calculate in earth bit size.
What is ST and specify its range of voltage.
how to compute kAIC? with formulas...
What are all present producing cost of Per KWH of various Fuel?
Why slip ring ind. motor power consumption is low compare to induction motor .same 90 kw motor used same load output
How Can You Relate Power Engineering With Electrical Engineering?
hi plz send me reliance placement papers..i.e electrical technical papers that have been asked in reliance test.
what is the saturation point of crgo lamination.
what is the function of impulse relay
can i use 4 number of circuit breaker as single phase manual change over switch? if yes then how plz also send ckt diagram at nazimzamurad@gmail.com
To make a basic instrumentation amplifier, it takes A One op-amp with a certain feedback arrangement B Two op-amp and seven resistors C Three op-amps and seven capacitors D Three op-amps and seven resistors
How maesure earth neutral value & how much maximum value value required in between earth & neutral.
