WHERE IS THE LIGHTING ARRESTER SHOULD BE PLACED IN
DISTRIBUTION LINES?
Answers were Sorted based on User's Feedback
Answer / s.l.manohar
near distribution transformers and out going feedrs of 11kv
and incomming feeder of 33kv and near power transformers in
sub-stations
Is This Answer Correct ? | 80 Yes | 12 No |
please 1st visit any substation
in 220 kv substation lightnng arrstr are installd at both
incoming and out going sides
also at both sides of power transformer
Is This Answer Correct ? | 17 Yes | 5 No |
Answer / syed ilyas
Usually LIGHTING ARRESTER placed at the HT side of the
Distribution lines
Is This Answer Correct ? | 7 Yes | 1 No |
an earth wire is being carried with the power lines, which
is at the top most of lines, that of (R,Y,B).
(this earth wire acts as an lightning arrester.
lightning arrester is also installed on the poles.
Is This Answer Correct ? | 10 Yes | 5 No |
Answer / ramanharikrishnan
lightening arresters to be installed either in primary side
(R,Y,B) of distribution transformer or in top of pole of
distribution transformer mounting.
Is This Answer Correct ? | 5 Yes | 0 No |
Answer / suresh
lighting arresters are placed near hv side of the
distribution transformer
Is This Answer Correct ? | 5 Yes | 0 No |
Answer / praveen kumar .p
lighting arresters are placed near hv side of the
distribution transformer
Is This Answer Correct ? | 6 Yes | 1 No |
Answer / ramkumar
lightning ARRESTER placed in receiving end point(main
incoming)and outgoing end point of that place(sending end point)
Is This Answer Correct ? | 6 Yes | 3 No |
Answer / hari
lighting arresters are placed at where there is chance to
damage the protection of lines.for example connection of
lines takes place.
Is This Answer Correct ? | 1 Yes | 0 No |
what happen if drive input fail momentry at 48.5 HZ frequency?
defination of transistor controlled series capacitor
how to reduce earth resistance in sandy soil.
how to calculate the no load current in transformer?
State ohm’s law?
difference between the applicability of nortons and thevenin theorem
What is Antipumping Function & If we have C.T how we find the Ratio ?
During speed control of dc shunt motor with flux control methode,when armature voltage is constant, How can it possible to increasing the armature current?
What is the difference between RCD & RCCB, Where it can be used
WHAT IS A DIFFERENCE BETWEEN A DC GEAR MOTOR AND STEPPER MOTOR.AND WHICH IS MORE APPROPRIATE TO USE FOR POSITION CONTROL PURPOSE?
why we are caling 440 volt 3 phase supply instead of 660 volt 3 phase supply? because each phase as a voltage of 220 volt. if anybody know the answer for my question please send it to my mail id. thank you.
3 Answers College School Exams Tests, Jindal Steel and Power, JIOL, NEC,
after syncnhronistion how generator speed controlled by grid