Answer / kashif ghulam mohammad

The function of relay and contactor is that to ON or OFF
contacts when we give voltage coil of both devices but main
difference is that relay does not use maximum 5 amperes and
magnetic contactor can be see in more than 50 or 60
amperes. and I also wanted to mention it that relay is used
only in controlling circuit and contactor are used both in
controlling and power circuit......

Answer / chris w

a contactor has bigger contacts than a relay. contactors are used for higher amps. They operate the same.

Answer / abdoulkarimubahizi

what are contactors and relay?how do they work?and what their application?in an electrical installation

Answer / gokulnath

For single phase (single output) connection we can employ relay.
For 3 phase connection ( multiple outputs) , we can employ contactors.

Answer / francesco

The word relay comes from very old times and was used to call a set of horses that pull a car, when a relay of horses got tired they switch it for a fresh one. In electricity the use of a relay is the same, you use a relay to switch between loads or between sources, You have one terminal with two possibilities, in a NC relay if not powered you're using one contact and when the relay is powered you use the other, or backwards if the relay is a NO. A contactor only has one in and one out so in a NO contactor when not energized the contacts are open and when energized the contacts are closed or backwards if the contactors is NC.
So relay has one in and two out possibilities, contactor has one in one out.

Answer / undala vijay bhaskar reddy

relay is sence the fault and give the trip sigal to the
circuit breaker.
contactor is a electro magnetic device.it is control the
circuit

Answer / miriam

contactors has hold on contact while relays does not

Answer / r. vidhya

contactor cannot receive high current or high voltage while relay can receive

Answer / sheik abdulla

The contactor serves the purpose of switching where as the relay give the signal.

Answer / a.narayanan.

RELAY IS AN ELECTRONIC OR ELECTRO MECHANIC DEVICE.IT CAN
OPERATE NORMAL OR ABNORMAL CONDITION TO TRIP THE C.B UNDER
PRESET VALUES IN ITSELF.

BUT CONTACTOR OPERATION NOT LIKE RELAY OPERATION.
IT CAN OPERATE ONLY BY CONTROL VOLTAGE IN SOME OF THE CIRCUIT.

what are the protection components on HT Side and LT side?

2 Answers  

What types of motors are used in cranes

9 Answers   BPDB, BUBT, CNH,

How to calculate & connection of 900KVA generator 2 sets & load(1500A)? How to choose cable size and ACB size for this load & generator? please explain me detail. Regards, Mr.Han

3 Answers   Powermec, TATA,

can I connect step down transformer(25KvA,240V Phase to phase)to output of online UPS(15KvA,440V PHASE TO PHASE) Load connect to TRANSFORMER is 13KvA,240V PHASE TO PHASE. please brief if it is wrong

1 Answers   DRJ ARDE,

How to calculate the cross section area for a 350 m cable, motor power is 26 kw???

1 Answers   Orient,

why transformer is rated in kva instead of kw?

1 Answers  

which phase is preferred for connecting 1 phase vt used for synchronizing OHL? WHY?

0 Answers   Siemens,

SMPS (Switch Mode Power Supply) unit is denoted by KW or KVA?

6 Answers  

what is the ckt diagram of a tubelight and is it the simplest ckt of electrical engineering and also the component?

0 Answers  

How to size Air Circuit breaker (ACB)? What is the most important factors?

0 Answers   ABC,

full form of flry b

0 Answers   KPIT,

Dear sir, please tell me how many day use CTPT transformer

1 Answers   Daya Engineering Works,