I have a situation to design sub-Distribution board/Panel
meant for feeding power sockets. In the incomer CAN i Take TP MCCB with Neutral Link and All the outgoing feeders with to sockets with TP MCCB and Neutral Link?
P.S : My System is IT Earthing
No Answer is Posted For this Question
Be the First to Post Answer
what is difference between sub-station and switch yard.
How to calculate the Harmonics losses in terms of cost/unit.
How can you limit the fault level in a power system?
Why is the diffrential protection in DG. What if the CT polarity is reversed while connecting for the same type of protection? How polarity can be made ok?
Why single phase induction motors are not self starting ?
operating Lt & HT voltages used in India?
Hello sir i m student of gtu .what is idp.
i) in which cases should we go for neutral and where should we go for ground? ii) in domestic supply we are getting 230v a.c.and what is the amount of current?
I FINISHED MY B.TECH IN EEE . I AM IN NEED OF A GOOD TRAINING INSTITUTE TO DO COURSES .. CAN ANYONE SUGGEST GOOD CENTRES IN TAMILNADU ,BANGALORE ,OTHER AREAS???????
HOW DOES THE ELECTRONIC ENERGY METER WORKS?
What are the basic components of the feedback control system?
what is the funda of earthing? Explain breifly about earthing?
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)