what is the effect of power factor on DG supply,i mean to
say what will the effect if we add capactors on dg supply.
Answers were Sorted based on User's Feedback
Answer / sachin
there will not be an effect on DG if we add the capacitor.
But normally we recommend to install capacitor bank where
load is fluctuating, unstable.
| Is This Answer Correct ? | 6 Yes | 3 No |
Answer / mahavir jagdev
The capacitor bank is kept to improve the power factor as most of the industrial load is inductive, hence to get the power factor to close to 0.85 or more the caoacitor bank helps. thus reduing losses.
| Is This Answer Correct ? | 1 Yes | 1 No |
Answer / praveen yadav
yes we can, but it can be upto safe life limit of extent of 0.95 P.F Usually dg set are designed over 0.8 P.F.
| Is This Answer Correct ? | 0 Yes | 0 No |
Answer / sumanth aptransco
idon't no about DG.in dc supply has no pf (unity).suppose we
connect c in dc it acts a open ckt.
| Is This Answer Correct ? | 1 Yes | 5 No |
we all know that corona is nothing but ionization of air around the conductor and there by allowing current to pass through ionized air.but we are not getting any short circuit in between the respective phases though the air turned as a conductive media between them??
Good day everyone,currently in our premise we using 30kw slip ring motor with resistance bank which we use as forward and reverse at conveyor bar handling. So,my question is how do we calculate the resistance bank which is suit the motor. Kindly,assist me... thank you
How much current flow in no load condition of a motor?
regarding safety what would u consider the most important rules to observe when inspecting electrical equipment?
0 Answers Reliance, Southco Utility,
Two liquids hot and cold in two vessels are there and an metal bar acts as a conductor of heat between the two vessels. what happens then. what happens after 24 hrs?
what is mutual induction principle?
please let me know , we have installed two separate motor for fire fighting system 1) 60 hp and 2) 15 hp the load is 74 AMPS and 20 AMPS then tell me the main power cable in Aluminum will be what thickness , the length is 225 mt from the main utility to fire pump house
difference b/w bus bar and tie line?if possible explain with eg:
Write down the name of 2 lady Bir Pratin of Bangladesh
In response to Mr Bikas. If fault current is 52 kA then what will be the CT specification
whats happen if we disconnect the NGR of alternator in running condition?. Generally we observed that transformer netrul is directly grounded but alternator connected with NGR, then ground?
what is the differance beetwen installation and errection ?
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)