Answer / prakul

motor starting torque will reduced.
AND AS WE KNOW TORQUE IS DIRECTLY PROPORTIONAL TO SQUARE OF
THE VOLTAGE.

Answer / senthil kumar

When the motor gets low voltage the following points are
obtained.
1.Low starting torque
2.low speed
3.High current
4.High temperature rise
5.High power factor
6.Noise

Answer / binay agrawal

motor speed will gradually down, but at below half of the
full voltage, winding can burn.

Answer / l.madhavan

motor run with low speed

Answer / gunasekaran

it is rotating very slowly

Answer / dilip dixit

WHEN LOW VOLTAGE APPLY TO THE MOTOR THAN TORGUE WILL BE
HIGHER AND FOR THIS SLIP WILL BE INCREASE AND MOTOR WILL BE
TAKING HIGHER CURRENT & BURNT AFTER CERTAIN LEVEL.

if we have 380 KVA DG. how to calculate Power Factor. With detailed formula

1 Answers  

what is the advantage of DC Motor over AC motor & Where its applicable ?

4 Answers   Torrent Power,

What is the disadvantage in proportional controller?

0 Answers  

What is vacuum circuit breaker.define with cause and where be use it device?

0 Answers  

4.In which type of welding is a pool of molten metal used.....

3 Answers   ISRO, SSC, Vizag Steel,

Which are Electrical componet and Electronics componet??

2 Answers   KarMic,

when we start the tube light, then it takes initially 1100 volt, after glow it takes 120 volt?(when we give 220 volt a.c.)

3 Answers  

what is the significant for using two types of voltage(line voltage & phase voltage)

1 Answers   NTPC,

how to decide the ratings of the busbar in electrification.give me the proper thumb rule or procedure

1 Answers   ABB,

What is Neutral Transformer? what is the use of this?

4 Answers  

first 3 men were there .again 3 came.total how much?

11 Answers   Wipro,

A 3-phase IM is supplied from 50 Hz system. It runs at speed of 1440 rpm and slip equal to 4 %. Calculate rotor frequency. A 50 Hz B 0 Hz C 4 Hz D 6 Hz

3 Answers