which is best ac or dc
Answers were Sorted based on User's Feedback
Answer / srikanth
When we compare in terms of power losses DC is best.
Commerical and Human saftey wise AC is best.
| Is This Answer Correct ? | 15 Yes | 1 No |
DC is the best source of power supply. Because we can store
the DC power in batteries, where as AC cannot be stored.
But for human safety purpose and universality AC has became
most economical way of production and consumption. Also in
case of power losses and harmonics DC holds up wrt to AC.
Generation of AC is quit simple wrt to DC, because
commutator and brushes are required in case of DC
production. AC is consumed as it is produced, ie; use it or
loose it. DC is exemption for this. there are many way by
which DC can be produced with out emitting CO2 to
environment, such as chemically, solar, etc. eventhough
there are some ways to produce AC ecofriendly, but there is
dispute of economy.
| Is This Answer Correct ? | 11 Yes | 0 No |
Both source are best in own areas
For transmitter and distributors AC is the best, AC motor
is lighter than DC motor;
For traction load, electrolyte, arc lamp, dc is the best
| Is This Answer Correct ? | 0 Yes | 0 No |
difference between high and low impedance BUS BAR relay??
draw singleline diagram of star to delta and dol starters
Why the ceiling fan has three blades, why not two,four or five?
How to calculate the sag of OPGW during stringing???
what parameters are should nessary for control technic dc drive(in rolling mills)?
1.In two wattmeter method if one wattmeter shows Negative reading then wat is reason? 2.Wat is the reason for low voltage in houses? 3.Wat is meant by current and voltage? wat is difference between the two?
Why dnt we generate 5-ph or 7-ph supply like as 3-ph supply
Whether the over frequency protection is turbine or alternator and why?
Difference between earthing & grounding.?
1. what is usage for power factor in industries?? 2.why we need to monitor power factor??
what is the relation between Sq mm of wire and its current carrying capacity?
why wire sizes are 3/29 or 7/29 and why not wire sizes are 2/29 or 6/29?
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)