Answer / ssnslm

there may be a possibility of sparking b/w slip ring and
brushes that will damage both.

Answer / rajendra sadaphale

if brushes are loose then it create sparking between
commutator and brushes and if it get tight there is
friction bitween them and reduce there speed.

Answer / kalimuddin

if itis loose then create spark b/n slip ring and if it is
tigth (heavily) then there is the possiblity of the damage
of the slip rings due to friction

Answer / sanjiv

If loose it will craate spark. If it is tighte it is
requirement only

Answer / vijay parekh

ti ensure pressure of all springs are even or equal load use our instrument to checking spring load instrument brush force meter m50 info@rishikesh.com this will save from damadging the brush and overloading
vijay parekh
www.rishikesh.com

1. A bomber drops a bomb from an aircraft flying at 2000 km/hr. at an altitude of 7km. The speed at which the bomb will strike the earth would be

0 Answers   KNJ,

how much current a 100 sq mm busbar will carry?

1 Answers   ABB,

* Signal transmission in sky wave propagation is due to ? a) Reforction of wave b) Reflection of wave c) Pierus through Inosphere d) None and Reason for this is????

2 Answers  

when we switch on the switch and load is not connected at home,is electricity wasted?

1 Answers  

why should the primary of transformer be connected in delta in a heat run test?

0 Answers   Bhel,

draw 3 phase rectifier diagram

0 Answers   Equate,

DIFFERENCE BETWEEN GROUND AND NEUTRAL?

4 Answers  

what is power?

1 Answers  

why indicated sypply only by 440V in 3-phase system.

2 Answers  

What is the Difference Between MCCB & ACB & VCB

3 Answers  

How do you commission a power Transformer?

1 Answers   EEI,

what is the purpose of supervision relay coil

1 Answers