Why only mesh earthing is used in G.S.S.?
Answers were Sorted based on User's Feedback
Answer / ajay singh bika
In GSS there is high fault current flows to the earth so
that there may be a potental difference due to this at
ground..... so if a person stands at the surface of a
substation he can get shocked due to this potential
difference so by this mesh earthing the potential can be
spread out whole the substation surface and this surface
become equipotential.
Is This Answer Correct ? | 2 Yes | 0 No |
Because of reducing resistance , other touch and step
voltage to be reduce, once fault happens then get maximum
ways to go into ground
Is This Answer Correct ? | 1 Yes | 0 No |
what is mean by amf
How to determine the short circuit current for breakers and VCB.
is there any current and voltage drop on liquid resistance starter water/soda tank ?
what is power factor
where does the unbalanced current flow in the delta circuit
How can i calculate heat load ?
If a current -8+6sin6t is flowing three ammeter, one is a centre zero PMMC meter, one is true rms meter and one is moving iron meter. What are the reading of these three meter respectively?
0 Answers National Insurance Company Limited,
Natural frequency in the control system represents nature of a. Transient response b. Oscillations c. Overshoot d. Speed of responce
How to calulate Voltage Drop for perticular lentgh of busbar (Cu/ Al)?
what is the function of a starter in a motor? explain RLC circuit.
why the earth conductor in top of the tranmission line ?
what is the difference between LATCH and FLIP FLOP