Interested to Buy Any Domain ? << Click Here >> for more details...
If carbon brushes spring tension either loose or tight,
what happen on Motor performance During Full load Operation?
- 5 Answers
- 10176 Views
- Electrex, HP, TATA, I also Faced
- E-Mail Answers
Answer Posted / rajendra sadaphale
if brushes are loose then it create sparking between
commutator and brushes and if it get tight there is
friction bitween them and reduce there speed.
| Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
Can we Co-ordinate relay in Load Break switch?
What will happen if i used 11KV earth ht kit to 11 KV / 11 KV cable termination?
Dear all, I want to use Induction motor to open and close a 1 ton door. How much power do I need. Thanks
Difference between a pilot wire and a normal conductor?
sir,in our plant we r using SATEC PM172E power reading meeters in HT panel side it is monitoring the MB data smart viewer(sever).but last one week we did not get readings inthe server only available in meeter.tell me how communicate meter and server. and also what steps we take for checking.
What is the function of probe in cro?
Which motor is 3.3 or 11kV more reliable, in terms of efficeancy,maintenance, reliability.
can any one know is sbi interview based on merit or based on roll number
what is the use of surge suppresser in 33 KV incoming panel. where it must be installed,inseries with incoming cable surge suppresser must be at incoming of the breaker are outgoing of the breaker
salam&hi, i need to know about how can i calculate an enough current for the new building before i submit it to the suppliers
Is single load(eg: three phase motor) having all the components like positive,negative,zero sequence components during fault condition?
what is Anti-pumping?
I AM A ELECTRICAL PANEL BOARD DESIGN ENGINEER.IF I GO ANY INTERVIEW ,TECHNICALLY WHAT ARE QUESTIONS I WILL FACE FROM INTERVIEWER?
for opening electrical shop, tips needed.
how to calculate kvar in Akiva
