Answer / shilesh kumar

Generally current carrying capacity of Al. is 0.8A per
sqmm and Copper is 1.6A per Sqmm.

Suppose we need bus bar for 630A, and we are going with
Aluminium bus bar

= 80*10*.8=640A
where 80*10 is size if bus bar usually available is the
market.
so we can use 80x10sqmm al. busbar per phase for 630A.

for TPN- (3.5)x80x10


If we are going with Copper bus bar
than we will use = 40x10sqmm per phase

= 40x10x1.6=640A
where 40*10 is size if bus bar usually available is the
market.
so we can use 40x10sqmm copper busbar per phase for 630A.

for TPN- (3.5)x40x10

Answer / vijaykumarht

Depending on the maximum load current the busbar size will
be determined. Usually for copper it is taken as 2 to 4 Amps
per square mm and for alluminium it is taken as 1 to 2 Amps
per sqmm.
The normal availability and design of the busbars is
25*5mm,50*5mm,50*10mm,60*10mm.

Answer / john philip

As per the load we have to calculat but we should choos a
good conducter with low resistenc value

Answer / lalit

.8mm=1 amp.

Answer / hasan 325

to calculate bus bar u must follow this formula :

wiedth x thickness x1.6 A

And also u can use this information :
A/mm2
100A = 2.5mm2
100-500 A=1.75mm2
500-1000A=1.2mm2
1000-above=1.1mm2

How does one convert an AC motor into a generator?

6 Answers   Bhel, ZK,

WHAT IS THE DIFFERENCE BETWEEN SHOP DRAWINGS/ DESIGN DRAWINGS AND AS BUILT DRAWINGS??

2 Answers   ACC, Al-Jaber, Dubai Group, ECEC,

how we can calcultae the short circuit level for bus bar

0 Answers   Jaiprakash, Panorama Apparels,

What is the type of electrical earthing recommended in hard rock area

2 Answers  

What will be the resultant out put voltage when two different voltage rating batteries are vconnected in parallel? pls. answer with example if available.

1 Answers  

What is the requirement of grounding the neutral of single phase generators on load? If the neutral is not grounded, what will be the effect?

0 Answers   HAL,

When connecting a loaded powerplant to the Huge grid,what are the factors to be considered and how the VAR flow will affect the system?

1 Answers  

What will happen if the generator turns in a wrong direction?

2 Answers  

Why transformer making noise during the operation?

2 Answers   TCS,

Any one can explaination about calibration with rotating sub standards?

0 Answers  

plz tell me,ht and lt panel terminals in substations explain beiefly

0 Answers   APCPDCL,

What is double delta conection in AC Motor? And can we done the double RPM of the motor by double delta conection?

1 Answers   vguard,