Interested to Buy Any Domain ? << Click Here >> for more details...
How to calculate busbar size & what is the procedure we
make for determine that?
- 35 Answers
- 217800 Views
- Auko Tex, Integra, PowerTech, Shadhin Group, I also Faced
- E-Mail Answers
Answer Posted / vijaykumarht
Depending on the maximum load current the busbar size will
be determined. Usually for copper it is taken as 2 to 4 Amps
per square mm and for alluminium it is taken as 1 to 2 Amps
per sqmm.
The normal availability and design of the busbars is
25*5mm,50*5mm,50*10mm,60*10mm.
| Is This Answer Correct ? | 57 Yes | 61 No |
Post New Answer View All Answers
completed BE & done apprentice at tneb & having experience 6 years. want to get c license. will apprentiship & BE be helpful for getting c license. will i get any preference by showing this?
What is meant by impedance? difference between high & low impedance ?
Is it possible to make a 5P10/ CT Ratio 50/1A Burden 5VA
why the protection turbo generators is most complex?
v/f drive basic princeple
what is POTT and PUTT explain?
On what basis do you decide the ONAN (Oil Natural air natural) or Dry type transformer for a project?
A 15 kw squirrel cage motor having a maximum efficiency of 90% on a continuous full load has temperature rise of 42 degrees celcius after 30 min and 52 degrees celcius after 1 hr under the above operation conditions. a) calculate its final steady state temperature rise on continuous load and the heating time constatnt. b) if the motor is operated on a short load for 9 min estimate its temperature rise. c) calculate the maximum overload that can be applied on a short, 9 min rating so that the temperature rise is the same as the final steady state temperature rise on continuous load.
Pl.brief me about Electrical power distribution system from Main generating station to Industry.What is the use of in between station.
while doing high voltage test on 11kv/433 distribution transformer why we only give 28 kv on hv side and 3kv on lv side for power transformers what is the value what factors it depends
What is current divider rule (cdr)?
why all the feeders are designed in a particular manner ... is there any reason for that???
what happened when we supply a dc current in dc motor?? can it worked properly?
A well system is when , no. of bus bar is less or more. Tell me the concept of it.
size of condotory fron voltage level
