what is the difference between the heat exchanger and cooling tower???????????

10 Answers   BARC, Essar,

---

FOOD ENGINEERING - QUESTION 23.2 : (a) A dryer reduces the moisture content of 100 kg of a potato product from 80 % to 10 % moisture. Find the mass of the water removed in such drying process. (b) During the drying process, the air is cooled from 80 °C to 71 °C in passing through the dryer. If the latent heat of vaporization corresponding to a saturation temperature of 71 °C is 2331 kJ / kg for water, find the heat energy required to evaporate the water only. (c) Assume potato enters at 24 °C, which is also the ambient air temperature, and leaves at the same temperature as the exit air. The specific heat of potato is 3.43 kJ / (kg °C). Find the minimum heat energy required to raise the temperature of the potatoes. (d) 250 kg of steam at 70 kPa gauge is used to heat 49,800 cubic metre of air to 80 °C, and the air is cooled to 71 °C in passing through the dryer. If the latent heat of steam at 70 kPa gauge is 2283 kJ / kg, find the heat energy in steam. (e) Calculate the efficiency of the dryer based heat input and output, in drying air. Use the formula (Ti - To) / (Ti - Ta) where Ti is the inlet (high) air temperature into the dryer, To is the outlet air temperature from the dryer, and Ta is the ambient air temperature.

1 Answers  

---

How can I treat a waste stream containing both hexavalent chromium and arsenic?

0 Answers  

---

Question 68 – Biochemical Oxygen Demand (BOD) could be calculated using the formula BOD = (DOi - DOf) (Vb / Vs) where Vb = Volume of bottle in ml, Vs = Volume of sample in ml, DOi = Initial dissolved oxygen in mg / L, DOf = Final dissolved oxygen in mg / L. (a) By using a bottle of Vb = 300 ml with sample Vs = 30 ml, find the BOD if DOi = 8.8 mg / L and DOf = 5.9 mg / L. (b) By using a bottle Vb = 600 mL with sample Vs = 100 mL, find the BOD if DOi = 8.8 mg / L and DOf = 4.2 mg / L. (c) Find the average BOD = [ Answer of (a) Answer of (b) ] / 2. (d) If the BOD-5 test for (a) - (c) is run on a secondary effluent using a nitrification inhibitor, find the nitrogenous BOD (NBOD) = TBOD - CBOD. Let TBOD = 45 mg / L and CBOD = Answer of (c).

1 Answers  

---

Does home used kerosene which is available in blue color can change its color after keeping number of years (say 8-10 years)? If yes, then in which color will it turned to? Will it change to yellow color or transparent color? Please reply with suitable technical suggestion/approach. Its an important question which was asked. I need a very strong technical reply. Please help me.

0 Answers   BP,

---

what is meaning of pid how it is useing controlers

4 Answers  

---

Explain what are some typical applications for glass-lined reactors?

0 Answers  

---

Question 55 - The differential equation is 3 dy / dt + 2y = 1 with y(0) = 1. (a) The Laplace transformation, L for given terms are : L (dy / dt) = sY(s) - y(0), L(y) = Y(s), L(1) = 1 / s. Use such transformation to find Y(s). (b) The initial value theorem states that : When t approaches 0 for a function of y(t), it is equal to a function of sY(s) when s approaches infinity. Use the initial value theorem as a check to the answer found in part (a).

1 Answers  

---

When using a pumping loop to mix two miscible fluids in a tank, when can the content are considered well mixed?

0 Answers  

---

QUANTUM COMPUTING - EXAMPLE 32.5 : In quantum teleportation, let (C0 + D1) (00 + 11) = C000 + C011 + D100 + D111. Ba = 00 + 11, Bc = 10 + 01, Be = 00 - 11, Bm = 10 - 01. (a) Find the values of 00, 01, 10 and 11 in term of Ba, Bc, Be and Bm. (b) Prove by calculation that (C0 + D1) (00 + 11) = 0.5 [ Ba (C0 + D1) + Bc (C1 + D0) + Be (C0 - D1) + Bm (-C1 + D0) ].

1 Answers  

---

CHEMICAL MATERIAL BALANCE – EXAMPLE 2.6 : According to Raoult's law for ideal liquid, x (PSAT) = yP where x is mole fraction of component in liquid, y is mole fraction of component in vapor, P is overall pressure and PSAT is saturation pressure. A liquid with 60 mole % component 1 and 40 mole % component 2 is flashed to 1210 kPa. The saturation pressure for component 1 is ln (PSAT) = 15 - 3010 / (T + 250) and for component 2 is ln (PSAT) = 14 - 2700 / (T + 205) where PSAT is in kPa and T is in degree Celsius. By assuming the liquid is ideal, calculate (a) the fraction of the effluent that is liquid; (b) the compositions of the liquid and vapor phases. The outlet T is 150 degree Celsius.

1 Answers  

---

hi all i have doe cheical engg, but i have to go for iob po interview so can anybody suggest me abt the kind of qns that can be asked.

0 Answers   Indian Overseas Bank,

---