Answer / r.s.teotia

14 gauge

Answer / dipak rakibe patil

24 Gauge

3. A vane 12.5 cm long, 8.8 cm dia was pressed into a soft clay at the bottom of borehole. Torque was applied and the value at failure was 55 N-m. find the shear strength of the clay on a horizontal plane.

0 Answers  

---

how many shuttering material required for 100 sqm

1 Answers   NRI, Raheja,

---

1. if only 1 slab of a floor get sagged, how could be it repaired? 2. if any footing gives the cube result, after 28 days less than 16 n/mm2 in spite of 20 n/mm2 what are the remedies ?

3 Answers  

---

How much cement and sand are required for 1 square feet of plaster at a thickness of 15 mm at a ratio of 1:4?

0 Answers  

---

Difference between Statics, Dynamics, Kinetics, Kinematics

5 Answers   Cinda,

---

---

What is code for designing a sheet pile?

2 Answers  

---

400 ku d/c clearess ketan hota hai?

0 Answers   Lanco,

---

we have a texmo make submersible water pump 5hp 10 stage what will be the total head & is it any thumb rule for calculating the head please reply urgently

3 Answers  

---

what is the productivity in aluminium shuttering per day

0 Answers  

---

please briefly explain calculating or estimating steel quantity for a RCC column?

0 Answers  

---

what is the spacing required for chairs for reinforcing in raft footing.

6 Answers   Earthcon,

---

ground floor columns and beams are reinforced by 4 Num's 16MM @ Corners AND 2 Num's 10MM @ centre.... And the nxt top floor columns and beams were lapped by 8 num's 12MM dia bars..... IS THIS CORRECT ????

2 Answers  

---