Answer / Santosh Shaw

Creating a detailed P&ID for a flow suction tank requires a visual diagram that may not be suitable for this format, but I can describe it here: The main inlet supplies raw water to the tank through a strainer to prevent large debris from entering. A level switch and a pressure switch control the inflow and outflow of the water. The level switch sends a signal to a controller when the water level reaches a certain point, triggering the pump to start or stop. The pressure switch does the same based on the pressure in the tank. An overflow pipe prevents the tank from overflowing. A valve controls the flow of water out of the tank. Protective equipment may include check valves, non-return valves, and safety relief valves.

hydrogen purity meter calibrating and commissioning procedure can be explained?

1 Answers  

---

why does mA signal preferred for signal transmission?

12 Answers   Emerson,

---

why we use npn sensor in vibration monitoring system

1 Answers  

---

What is the diffrence between digital signal processing and discrete signal processing?

1 Answers  

---

How to calibrate Field bus transmitter? procedure ?

1 Answers   Parco,

---

what do you mean by CJC (cold junction compensation).?

5 Answers   Jindal,

---

How to calibrate electronic type level switch low?

1 Answers  

---

How do you measure g's?

5 Answers   Aramco, GNFC, HPCL, Polmon, Thermax,

---

regarding level tx i would like to know how to select the range of the level transmitter in a closed drum(steam drum or deaerator)?

1 Answers  

---

cheapest instru-- PMMC, EDM, rectifier, thermocouple.

3 Answers   ONGC,

---

What is Trim?

1 Answers   Gujarat Borosil,

---

What is difference between radial vibration and axial vibration explain in detail .

1 Answers   Emerson,

---