Answer / tyrkrv83

Valve's trim is a collective name for the replaceable parts, in a valve. A typically Trim design includes a disk, seat, stem, and sleeves needed to guide the stem.

A valve's performance is determined by the disk and seat interface and the relation of the disk position to the seat. Because of the trim, basic motions and flow control are possible. In rotational motion trim designs, the disk slides closely past the seat to produce a change in flow opening. In linear motion trim designs, the disk lifts perpendicularly away from the seat so that an annular orifice appears.

When doing a liquid seal on a differential flow transmitter , most of the time the sealing liquid will be heavier then the process fluid. For wich application will the sealing liquid be lighter than the process fluid if transmitter is mounted below the process line.

1 Answers   Chevron,

---

pl give the guidance for DUBAL written test

1 Answers  

---

Q- Which of the following is Close loop system - a-)respiratory System b-)traffic light system c-)washing machine d-)Room heater my option is A, what is our take on option B & C

4 Answers   Sail,

---

how to solve temperature error in compressor?

1 Answers  

---

Difference b/w SCADA & DCS

8 Answers   Siemens,

---

How to measure Flow of air line,what is the procedure of creating DP in line to measure Flow!

3 Answers  

---

Pressure transmitter working Principles?

1 Answers  

---

what is installation and commissioning of (fat & sat) of power plant dcs ? this question keeps in desirable conditions of one company .

1 Answers  

---

what should be minimum length and size of impulse line for steam flow orifice and feed water orifice? asked by sanjay parihar

1 Answers   Birla,

---

how to use level tranasmitter in closed tank application.?

3 Answers   Dalkia,

---

WHAT PRINCIPLE OF GAS ANALYSER( CO,CO2,N2)

2 Answers   Jubilant Organosys,

---

What is the exact differences between HART,FOUNDATION FIELDBUS,PROFIBUS?

1 Answers   Jubilant,

---