why we use npn sensor in vibration monitoring system
Answer / faiyaz ahmad
Bentley neveda system used NPN transistor or NPN transistor give the negative voltage -9 volt that's why vibration probe give a negative voltage
| Is This Answer Correct ? | 0 Yes | 0 No |
, Instrument Index, P&ID review, I/O schedule, datasheet, DCS / Analyzers specifications, loop diagrams, hook-up drawings.
If range of 3-15 psi, a multiplying relay with a 1:2 ratio would give what output pressure for 6 psi input?
how to install the Ph and Conductivity analyser? is there are any procedures which has to be maintained.
NPN transistor, SCR, Zener diode, LED, Varactor diode, Vortex meter, RTD, Resistor, Crystal
How to check loadcell working or notworking
What is negative range in transmeter?
what are the types of a thermocouple
What you mean by multi stage control vavles?
Why trim span ? How?
What is the difference between Error and Offset.
what is the difference between Ethernet unmanaged and managed Switch?
What is the difference between HMI,SCADA and MMI,not abbrevation?
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)