Answer / sam

It is easy. Find a manual and read it, that's what we all do.
The manufacturer can give you all the details of a specific
instrument much better that what anyone else can.
Good luck

what is intrinscily safe system and where we use?

0 Answers   DEWA,

---

What properties or parameters to be taken into consideration for protection while selection of Dcs controller.

1 Answers   JPL,

---

i want to control the temp of sand(welding flux) between the range of 150deg C to 170deg C. sugges me sum temp control method without PID controller.

1 Answers  

---

for oil & gas industries which zone is normally preferred? why? give its example?

0 Answers  

---

why in vortex flow transmitter dcs range is configuring less than sensor range. eg (sensor range 500-25000 kg/hr and dcs range 0-24000 kg/hr).

1 Answers   Daelim,

---

What is the IEC Standard for PLC I/O Terminal wiring Procedure?

1 Answers  

---

can we create an interrupt in plc through scada?

0 Answers   Glensol, TATA,

---

Good Evening all.My question is - For a feed water line to an equipment if i need to measure the flow we will use orifice /magnetic/vortex depend on cost/spec.If i need to measure a ''Alarm''signal and ''Interlock'' from one point i think we can use orifice type in one location with 2 different tapping points - one for alarm and one for an interlock to flow valve..If in case i need to have both these signals(Alarm & interlock) from magnetic flow meter,is it possible??will 2 seperate sensors will be located inbuilt r we can program it ??..i thk we can have one transmitter with these 2 signals...need to know any technical issues are there?pls clarify

3 Answers  

---

what is the formula for changing Range of Transmitter from X mmwc to some Y mmwc with respect to DCS NCMH flow range from x NCMH to y NCMH?

1 Answers   HCL,

---

what is the difference between cold loop and hot loop

2 Answers  

---

how can loop single 4-20 ma to two isolation amplifier? i mean i have two isolation amplifier with 4-20 ma input and 1-5 v output.can i done series connection ?

1 Answers  

---

why we use 3 wire rtd direct wiring for temperature measurement instead of temperature transmitter like bearing temperature

0 Answers   ABG Energy,

---