how to calculate the power factor when instantaneous voltage and current has harmonics in it ?
No Answer is Posted For this Question
Be the First to Post Answer
why we use MV panels??? what's r all the needs
why do we need a 4th wire in 3phase 3wire transmission line
what transformer we used normally and upto which kva?
How to check the specific gravity of the two 12 V batteries connected in series to a 24 V UPS and inverter ? will we have to disconnect all the connections and turn off the UPS and inverter or not ? will we have to check specific gravities in each cell of the two batteries ? what is the name of the instrument that is used to check the specific gravity and whats the procedure to check the specific gravity with it ? thanks
What Maximam Gap Taibaar & Bush
What is mimimum di -electric strength value for 33 KV transformer OLTC oil
How to find synchronous motor speed formula Ns=120f/P ?....
How to calculate the FUSE rating?
How do you select a cable size(cu&Al)for a particular load?
why low pressure side of the turbine is connected to the alternator and not the high pressure side??
when voltage increases then current also increases then what is the need of over voltage relay and over current relay? can we measure over voltage and over current by measuring current only?
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)