the site measured knee point voltage of protection class
CTs should be greater than rated knee point voltage? what
about meetering class CTs. Should it be below the rated
knee point voltage?
No Answer is Posted For this Question
Be the First to Post Answer
What is bushing?
If short circuit ratio is high is it bad or good for a machine then tell the reason...
All tape of electrical questions Answers tape of motor transformer e.o.t crane
0 Answers Afcons, Honeywell, Manlift, SIMS,
Do you know the alignment of a motor?
I'm looking for a softcopy manual set for a Credence ASL- 3000. Anyone know where I can get it?
how "rabbit ACSR" conductors are more efficient than "weasel ACSR" conductors
why we use 25 kv in railway .not 11kv, or 33 kv
why it is necessary to short and ground of a current transformer secondary side?
What should be the magnetic balance test values for a 3 phase delta/star connected single primary dual secondary winding transformer (90 MVA / 2 X 45 MVA TRANSFORMER)
current and voltage equations for a star connected load fed from a delta connected load.
what is electrical machines
KVA transformer of different frequencies of 50hz,100hz,500hz&1000hz. which one of these transformer has big size? Give reason
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)