why is use the star and delta connection and difference
Answer / venkatesh
IN STAR CONNECTION:
the starting or finishing ends (Similar ends) of three coils are connected together to form the neutral point. A common wire is taken out from the neutral point which is called Neutral.
IN DELTA CONNECTION: In DELTA connection, the opposite ends of three coils are connected together. In other words, the end of each coil is connected with the start of another coil, and three wires are taken out from the coil joints
Is This Answer Correct ? | 3 Yes | 2 No |
what is the difference between capacitive voltage transformer & inductive voltage transformer.
what is the step by step formula for calculating bus bar phase and neutral size of a panel board.suppose the incomer of panel board is 100A..???step by step answer please
What is the drawback of static coefficients?
how to extend relay operating timing in 24V dc relay card (without using Timer )
can we increase our frequency rate in INDIA?
What the reson for frequant instantaneous ground over current fault in our sync. Generator... 15 triping in 24 hr...
1 Answers HCPL, Jhunjhunwala Vanaspati Jhoola, Regen Powertech,
How to find HT side and LT side(of a transformer),with the help of a voltmeter?
1 Answers Odisha Power Generation Corporation OPGC,
in 11kv generators the neutral point is connected to earth via earth coil while in the 33 / 11 kv transformer the neutral point is connected to earth via earth resistor why?
who is invented transforner (230v).......
i have to use generator in my project,which gen. i can use?
when the supply of MSEB is cut off & all the load of the industry is driven on generator at that time the capacitor which is connected in industry for power factor control is switched off why?
How to covert the ac to dc and how to control the dc output?