Interested to Buy Any Domain ? << Click Here >> for more details...
we know the value of the power factor is 0.8, we know the
power factor is not depends upon the load ,then why we cant
design the power factor in transformer ?
- 1 Answers
- 2560 Views
- I also Faced
- E-Mail Answers
power factor I.e the value of cosine angle between voltage and current .it is 0,6(or less) to 0.9(max 0.99) but it is not fix as 0.8 that is why transformer is rated.
| Is This Answer Correct ? | 0 Yes | 0 No |
What are the reason of unbalanced secondary voltage of HT transformer 33kv/6.6kv ? Incomming voltage is balanced.33kv each secondary voltage 6.6 kv 6.4 kv 6.4 kv At no load conditions.
what should be the BDV value Of 11/132kv power transformer
what is difrent between earthing and ground
why we are not giving the zone 1 trip command to the master trip relay
Please help me regarding my one concern. - During earth pit testing we noticed that the Clean earth pit and dirty earth pit showing continuity (Resistance value - 5ohm) . I want to know that if both earth pit have separate location and there is not internal looping between PIT then why such continuity is showing on it . Because of this issue the field side all earthing point showing short. In PLC panel we are providing two types of earthing cable which is coming from separate earth pit (Clean and Dirty earth pit) because of earth PIT showing short our PLC is not complying spec . please help regarding this issues.
why should small green grass ans small plant should not be there inside the transformer Yard in the factories
why free wheeling diode is connected across inductive load
16 Answers NTPC, Omaxe, Wipro,
what is Ith current?
what are the stresses in circuit breakers ?
How to make two bulbs glow Alternatively?
which one is rotating transformer-single phase induction motor or 3 phase squirrel cage motor?
One of our gas turbine generator unit "1st stage rotor ground fault" alarm was occured several times. we tried to measure some voltage vulue ground fault protection relay (UNS3020a made by ABB and we measured the value of: Ground: 0.9VDC 5V: 5.8VDC 24V: 23VDC u+: 300 – 350mVAC Rf1: 17.5mVAC Rf2: 17.6mVAC The unit still running and the alarm was reset. As of 6pm yesterday and unitl now no alarm happened again. I our protection relay was defective?
-
Civil Engineering (5086) - Mechanical Engineering (4456)
- Electrical Engineering (16639)
- Electronics Communications (3918)
- Chemical Engineering (1095)
- Aeronautical Engineering (239)
- Bio Engineering (96)
- Metallurgy (361)
- Industrial Engineering (259)
- Instrumentation (3014)
- Automobile Engineering (332)
- Mechatronics Engineering (97)
- Marine Engineering (124)
- Power Plant Engineering (172)
- Textile Engineering (575)
- Production Engineering (25)
- Satellite Systems Engineering (106)
- Engineering AllOther (1379)
