we know the value of the power factor is 0.8, we know the
power factor is not depends upon the load ,then why we cant
design the power factor in transformer ?
Answer Posted / pradyumna171
power factor I.e the value of cosine angle between voltage and current .it is 0,6(or less) to 0.9(max 0.99) but it is not fix as 0.8 that is why transformer is rated.
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What do you understand by external characteristics of a d.c. Generator?
Do any one know exacatly when the results for NHPC held on 8th march 09 for engineering trainees will be released ?. if so please post it, i'm eager to know it.
Which types of gate insttaled in static switch. Please give me answer.
what is the minimum requirement gigaohms for the insulation test using 5kv in 300mm xlpe cable
How many types of protection relays are there based on the characteristic?
Can we use BS 6651 and BS EN 62305 standards for computer room lightning ptotection in substation?
If any one's require of phoenix contact like( relay , termilnal block , surge protection device ) , product please contect me 09878206357 chetan verma
Can anyone provide with a SLD for HT panel installation for a 33KV line and distribution end has three 1.5MV transformers. Is it suitable to use OCB or VCB and also provide me the suitable rating and its connection diagram.
What is time invariant system?
Why is the starting current high in dc motor?
Draw the vector diagram and condition for the following: 1) Dyn1 2) Ynd0 3) YnYn0
Why 9KV surge arrester having 7.65KV of MCOV?
Can the output voltage of a rectifier be greater than the input AC voltage without the use of any voltage multiplier in the circuit??please provide the explanation too..
my UPS suddenly goes off and all panel light also blow off.This happens even main electric supply is not interrupted.After some time it automatically starts functioning normally.Batteries are new.
Define step response?