what is diffrance between FF & SMART, explain with difination
No Answer is Posted For this Question
Be the First to Post Answer
I have 0.75mm sq multicore cable (IS type) , can use instead of same type but 1.5 sq mm cable ? Note : The distance is around about 150 meter.
How oil line flow measured?eplain about instruments used and working principle?
what is piezo electric transducer?its principle?
why twisted pair of wires is used in instrumentation ?
in DCS or PLC we can not put all ai or di,there is calculation through which we can accomodate certain no of digital and analog signal.I need to know that calculation
WHAT IS THE Differance b/w on/off & pid control valve?
how to do dynolab wind speed sensor loop test, how to simulate value,i have simulate mA 4-20mA but not responding in DCS faceplate, please kindly advice me any one.
Q- voltage source of 12v is driving the circuit.if circut draw the current of 0.5A them source voltage will became 11.8v.what is the power dilevered by source when circuit draw 5A current ?
What is the procedure of calibration of Load cell?
what is the diffirence between Earth and Neutral
what is start up vent valve ? why it is used in boiler?
8 Answers ACC, Bhushan Power Steel,
In Increasing temperature why thermocouple used and RTD is not used. Both RTD and Thermocouple have in Range of uses.