POSSITIVE PULSE IS APPLIED TO AN INVERTER INPUT.THE TIME FROM THE LEADING EDG

POSSITIVE PULSE IS APPLIED TO AN INVERTER INPUT.THE TIME
FROM THE LEADING EDGE OF THE INPUT TO THE LEADING EDGE OF
THE OUTPUT IS 10 ns. THE TIME FROM THE TRAILING EDGE OF THE
INPUT TO THE TRYLING EDGE OF THE OUTPUT IS 8 ns. WHAT ARE
THE VALUES OF tPLH and tPHL?

Question Posted / dinkar

1 Answers
2386 Views
I also Faced
E-Mail Answers

POSSITIVE PULSE IS APPLIED TO AN INVERTER INPUT.THE TIME FROM THE LEADING EDGE OF THE INPUT TO TH..

Answer / Pramod Kumar Jaiswal

In pulse-width modulation, tPLH (Pulse On Time or Pulse High Time) is the time during which the output signal is in a high state (ON), while tPHL (Pulse Off Time or Pulse Low Time) is the time when the output signal is in a low state (OFF). Given that the leading edge of the input pulse to the inverter lasts for 10 ns, and the leading edge of the output pulse lasts for 8 ns, we can calculate tPLH as 10 ns and tPHL as 12 ns. However, please note that these values may be affected by other factors such as rise and fall times.

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Instrumentation Interview Questions

what is the full form of psig.

8 Answers

What are different types of orifice plates?

1 Answers

1. What means HART communicator / where it is used / how to use it? 2. Types of Thermocouples and its temperature ranges / output of thermocouple? 3. Types of RTDs and its temperature ranges / output of RTD? 4. Idea about Temperature Transmitters? 5. Difference between Analog and Digital signals? 6. Difference between “2 wire” and “4 wire” system / instruments? 7. Difference between “Potential” and “Potential free” contact? 8. Types of flow meters / transmitters? 9. Types of level transmitters? 10. Difference between “Power/Control” cable and “Instrument” cable? 11. What means “shield” and “screen” in cables / how it is useful? 12. Draw a schematic of closed loop circuit of flow / level / pressure / temperature? 13. Idea about calibration of Control valve / positioned / I/P? 14. How to bypass a digital/analog signal in PLC/DCS by hardwire and software?

6 Answers JSL,

Dead weight tester & comparator for calibration , which is more accurate , what is the application.

1 Answers Bapco Bahrain Petroleum Company,

wHAT IS BURST MODE IN TRANSMITTER?

1 Answers Bhel,

Regarding , there is an air cooler which control the fans(50% of AV FANS) by temperature in outlet , and the louver of Air cooler is controlled by HIC from control system , So if on Air cooler we will consider 2 individual I/P converter or positioner?

1 Answers Chagalesh Consulting Engineers,

What is the Flow rate ?

2 Answers

How a oxygen sensor & analyzer work at boiler or furnace, whatâ€™s the principle & science is beyond this, How O2 sensor scene & convert signal & move toward analyzer & analyzer show reading in percent?

1 Answers GS Engineering Construction, KNIC,

How to gennerate earth leakage monitoring alarm for solenoid valves in control system?

2 Answers

What is smart positionar

2 Answers

What is paid how it works

0 Answers KOC,

What is the standard height for stancion supports?

4 Answers

For more Instrumentation Interview Questions Click Here