Answer / rethina kumar

generally we use this constant for rod lap (58D) D=diameter of rod ( answer in mm )

while we connecting 20mm rod to 20mm rod lap will be (58x20=1160mm)
connecting 16mm to 16mm lap is (58x16=928)

in this question 16mm rod is laid above 20mm rod , so lap length min 80mm max 928mmm

Answer / as.

When two bars of different dia lapped together, lap length is provided based on lower dia.
Here both both 20 & 16 mm used. So, lap length is based on 16 mm. Normally, we provide lap length 50 times dia of bar. So lap length in this case will be 800 mm.

Answer / shekarpuppala127

80mm

Answer / abid

58(d1=d2)/2=lap legth
58(16+20)/2=1044

Answer / p.vimal raj

20MM DIA ROD LAP LENTH =920MMM....
16MM DIA ROD LAP LENTH =73 MM

1)What's are the diff. types of column based on loading? 2)Is there any difference bitween Development length & Anchorage Length? 3) What is the basic diff. between one way & two way slab? 4) Where should use OPC & where should PPC?

3 Answers   TPSC,

Please tell me 1 Sqm Steel 14mm center to center .200,.200

2 Answers   Al Shalawi,

1) what is the use of pin and plate vibrators during slab casting? 2) how much cement bags are required for 1sqm 4inch brick wall? 3) Is it viable to provide overlap at column , beam & slab junction. if no why? 4) if bar dia is changing in column reinforcement , which dia bars overlap is considered? 5) what is isolated and ecentric footing?

4 Answers  

numerical example of solving water cement ratio

3 Answers  

how to calculate bearing capacity of soil

6 Answers   L&T, Reliance, Sujala Infrastructure, TATA,

# 1, What should be the Maximum Water observation of wood # 2. Is Alluminium is an alloy or not

2 Answers   Brigade,

What is difference between limit state and working stress method? How it is applies in building structure.

2 Answers   L&T,

which type of crust is best suitable to develop flexible pavement in rural roads i.e either with wet mix macadam or Water Bound Macadam and its reasons.

0 Answers  

I have an span length 16 ft c/c

0 Answers  

how to consider the lap length of a bar in IS code.

7 Answers  

What is the difference between Stress & Strain?

2 Answers   NCC,

asubmerged weir is one in which the water level on the down stream side of the weir is just at the crest level below the crest level above the crest level at stamp elevation as water surface on upstream

0 Answers