what if i want to lap a 20mm dia and a 16mm dia together wat
will be the lap length??
a) 1m
b) 80mm
- 5 Answers
- 10056 Views
- I also Faced
- E-Mail Answers
Answer Posted / rethina kumar
generally we use this constant for rod lap (58D) D=diameter of rod ( answer in mm )
while we connecting 20mm rod to 20mm rod lap will be (58x20=1160mm)
connecting 16mm to 16mm lap is (58x16=928)
in this question 16mm rod is laid above 20mm rod , so lap length min 80mm max 928mmm
| Is This Answer Correct ? | 7 Yes | 2 No |
Post New Answer View All Answers
Detection of a beam & a girder are––––
in levelling operation the first site on any change point is back site the second site on any change point is fore site the line commenses with fore sight & closes with backsight the line comensses with back sight & closes with fore sigh
How many square meter can a worker/labor demolish a structure per day?
What do you mean by bond? What are the different types of bonds?
How to calculate paint drums per meter square
What should be the maximum allowable time for placing ready mix concrete? The specification requires concrete placement within 90 minutes of batching at the plant. What is the significance of this 90 minutes & should this be used as a rejection criterion? What effects does the concrete has after that time period?
What is the difference between EPC,DBOOT and BOOT.
What is M40 _ TOR - EQ and B.F.S
How much does the leaning tower of pisa lean?
What is the diff between cad & cadd?
Can a wave happen in the middle of the ocean like in the movie poseidon 2006?
Dear Engineers, Can you please advise me the material requirement to construct a room 4 M x 4 M 1. No. of Standard Brick 2. Requirement of Cement Bags 3. And Concrete for Steel, Cement, sand, etc Thanks
what is the name of shuttering oil used in oman
find the discharge of water through a horizental venturimeter having 400mm dia at the inlet main and 150mm dia at thorat.if the diffrential gauge between inlet and thorat shows a pressure head of 25cm mercury. assume coefficient discharge 0.98 and specfic gravity of mercury as 13.6.
What happens when,in Prestressed girder the HDPE duct and cone size is provided more than required? (technical answer expected)
